 |
|
Spray Tip Data Sheet |
Flat Spray
Pattern |
 |
Angle
110° |
Dimensions
15" x 2" |
Description
6" away from stock, spraying straight down. If nozzle is angled, pattern is broader.
If nozzle is further away, pattern is longer. |
 |
80° |
11" x 2" |
See Above |
| |
50° |
8" x 1 ¾” |
See Above |
| |
25° |
4" x 1" |
See Above |
Flat Tapered
Edge Spray Pattern |
 |
Angle
90° |
Dimensions
15" x 2" |
Description
TK1.5 Deflected Fan
Fan pattern sprays out the
side of the nozzle.
|
 |
Solid Stream
Pattern |
 |
|
Dimensions
1/2" x 1/2"* |
Description
.0003 Pin Point
*1/2" round when 6” away from stock with pump at
1/2 or greater lubricant capacity. Orifice opening is .047. |
 |
|
1/2" x 1/2"*
|
.0003 Pin Point
*1/2" round when 6” away from stock with pump at
½ or greater lubricant capacity. Orifice opening is .028. |
Full Cone
Spray Pattern |
 |
|
Dimensions
5" x 5"* |
Description
TG2 Full Cone
5” round when 6” away from stock with pump at full lubricant capacity.
Orifice opening is .047. |
 |
|
4" x 4"*
|
TG1 Full Cone
4” round when 6” away from stock with pump at ¾ lubricant capacity.
Orifice opening is .036. |
| |
|
2" x 2"*
|
TG0.7 Full Cone
2” round when 6” away from stock with pump at ½ lubricant capacity.
Orifice opening is .030. |
| |
|
1" x 1"*
|
TG0.5 Full Cone
1” round when 6” away from stock with pump at 1/4 lubricant capacity.
Orifice opening is .024. |
| |
|
1/2" x 1/2"*
|
TG0.3 Full Cone
1/2" round when 6” away from stock with pump at 1/8 lubricant capacity.
Orifice opening is .020. |
Note:
Any cone pattern spray tip should NOT be used in an application where a
straight oil product is being used. The reason for this, the design of the
spray tip does not allow the straight oil to dispense in a swirling motion,
leaving it a stream type pattern. Factory recommendation is that a fan pattern
spray tip be used with a straight oil product.
|
